Updating the Firmware On the eInstruction Pulse Remotes

There have been firmware updates to the RF receiver for the Mobi wireless tablet and firmware updates for the Mobi tablet itself. There also have been firmware updates for the CPS Pulse RF receiver. The Pulse remotes also have firmware updates. That is what this blog is about. This update allows a user to enter more than 20 characters to answer an essay question in CPS using the Pulse remotes. The process is relatively fast unless you have many sets to update. The first step is to see if you need to update the firware on the remotes you have. You can find out what version you are running on your remotes by pressing the menu button (located at the top of the remote), then press the right arrow key six times until you see “diagnostic”, then press send (the key below the menu button). The old version firmware on the remotes is 00.47. The new version is 00.54.


Ok, here is the update process. First of course make sure you have the RF receiver plugged in the USB port of your computer and turn on all the remotes. Also, make sure that the RF receiver and the Pulse remotes are on the same channel. Click on the eInstruction icon in the system tray and choose “eInstruction Device Manager”. Right click on the icon for the Pulse RF receiver and choose “properties”. Press the control and shift keys at the same time. You will see two more tabs appear, “update keypads” and “update base”. If you haven’t updated the firmware on your RF receiver, click the “update base” tab and update the RF receiver. Click the “update keypads” tab to update the firmware on the remotes. Click “browse”, select the 0.54 folder and click “open”. Select “English Pulsestring” and click “open”. Click “update”.

You will see a message “You are about to upload new firmware to your Pulse keypads. Do not remove the USB receiver during this process. If you are sure you want to continue, select ok, otherwise choose cancel to abort the update.”

The next step is: “Manually join all CPS Pulse clickers to channel 21 by pressing digits 21 (your channel may be different) on each clicker and then pressing send. When all clickers have joined, press ok.”

The next message displayed is: “The firmware update is currently being sent to all CPS Pulse clickers. The clicker LCD may display blank during the update, please wait until all clickers read powering down and have powered off completely and then press ok to continue.”

The last message you will see is: “The CPS Pulse firmware has been successfully updated. Press ok to end the update process.”

I hope that helps. Thanks.